- This topic has 2 replies, 3 voices, and was last updated 5 years ago by
.
-
Posts
-
Looking to buy an angle master for setting the angles on pat traps.
Bryan Pierce does make them anymore I called him, he told me to ask
around to see if anyone is not using the one they bought and wanted
to sell it. Thanks in advance please call me or send and e-mail.
920-373-0947
mikehmay@gmail.comMike May
Brown County Sportsman’s ClubAccording to a conversation with Bryan about 2 weeks ago, he said he was developing a new device which would take the work out of setting targets. He didn’t say when this would be available or what the cost might be but he said “with it target setting will be a snap”. I can’t give any details as I have no more information on it.
If you have the G series Pat trap serial # 2740 up when you are facing the machine from outside the trap house looking at the hydraulic cylinder measure 2 5/16 inches from the left inside edge of the cylinder cap to the left edge of the left reed switch #12 place the 4 1/4 inch 2 hole target spacer (supplied with the machine) in the groove tight to left reed switch #12 move the right angle reed switch #11 tight to the right edge of the 2 hole target spacer bar. Machine is set for 2 hole targets. Reference page 24 Diagram 91 Pat trap manual for G series traps. Pretty simple in my book.
- You must be logged in to reply to this topic.